You need to upgrade your Flash Player or to allow javascript to enable Website menu.
Get Flash Player

AS-i/PROFIBUS DP Gateway/Link
in Protection Class IP65

AS-i Specification 2.1


Entirely powered by AS-i


AS-i Scope function






Article no.




AS-i: electromechanical interface
(penetration technique)
PROFIBUS DP: heavy gauge terminals and
cage clamp terminal blocks

AS-i: electromechanical interface
(penetration technique)
PROFIBUS DP: via M12 connector

Operating current

Master power supply A, approx. 200 mA out of AS-i circuit

Operating voltage

AS-i voltage 30 V DC

PROFIBUS Interface

according to DIN 19245 part 3

Baud rates

9,6 KBaud up to 12000 KBaud, automatic recognition


imaging of the AS-i slaves as I/O data of the PROFIBUS.
complete diagnosis and configuration via PROFIBUS

AS-i cycle time

150 μs*(Number of slaves + 1)



LED display

AS-i slave addresses and error messages

LED green (power)

Power on

LED green (Bus active)

PROFIBUS Master recognized

LED red (config error)

Configuration error

LED green (U AS-i)

AS-i voltage OK

LED green (AS-i active)

AS-i normal operation active

LED green (prg enable)

automatic Adress Programming enabled

LED yellow (prj mode)

the Master is in configuration mode


2 (mode/set)

Voltage of insulation

≥ 500 V

EMC directions

EN 50082, EN 50081

Ambient operating temperature

0°C ... +55°C

Storage temperature

-25°C ... +85°C



Dimensions (L, W, H)

90 mm, 80 mm, 70 mm

Protection category (DIN 40 050)

housing IP65


355 g


  • Software "AS-i Control Tools" (art. no. BW1203)
  • Serial PROFIBUS Master (art. no. BW1258)
  • PROFIBUS DP Master Simulator DP V0 and DP V1 (art. no. BW1257)
  • Transmission cords (art. no. BW1097)

Информация взята с официального сайта компании Bihl+Wiedemann


О компании Продукция Производители Проекты Клиенты Контакты Карта сайта Форум